Gen2 to Gen1 front clip conversion

[ONEWYR]

Today I made some good progress I got the gen2 inner fenders and core support removed and got the gen1 put in I still need to finish bolting the inner fenders to the firewall. When i finish bolting the inner fenders on I will need to address the radiator mounts and trim the fenders before i bolt them back in. i didn't take pics of the inners and core support back on because it looks just like the first pics I took if it doesn't rain tomorrow I will finish bolting the inners back in and do the rad supports and start securing the harness back in place I figure i still have another couple of days and the conversion will be complete.If you do this swap the way I am by swapping inners it is pretty straight forward the biggest pain in the ass is the fact that you have to drill out about 50 spot welds and that is no exageration. here are some pics of all the sheet metal removed from the front.