68 Bronco

[wepuckett]

Small is correct for that year assuming it is original housing. Seals will live in housing. Ur good to go. Make sure the geniuses at the parts store didn't give u tapered bearings. Glad things are coming together.

Sent from my GS3 on Cyanogenmod with T2.

I will double check that I actually took the axle shaft too the parts store to confirm the bearings they had on hand where not them, and they had to order them in, so should be right but will double check.

I saw the spot your talking about living in the housing, but they still need pressed on correct?
Either way as you said before I need to have the wheel studs pressed in.

Thanks yeah once I get the axle back under I can focus on the replacement engine getting it painted and in. Since I am swapping engine figure I ought to use the aluminum radiator I have only wish it was an automatic radiator rather then for straight drive.