12-12-2014, 09:03 PM
Well bearings are pressed on now along with the wheel studs that I needed to fix or replace. Made something in machining class to tap in the seals should get that done and axle back together tomorrow and hopefully under the bronco again.
Also picked up the AOD from the trans shop today cost 380 to have rebuilt and a new torque converter. So hopefully after the 1st of the year I will have the engine in and be ready to get trans in and figure out how to move that crossmember back.
Also picked up the AOD from the trans shop today cost 380 to have rebuilt and a new torque converter. So hopefully after the 1st of the year I will have the engine in and be ready to get trans in and figure out how to move that crossmember back.