05-26-2008, 12:07 AM
Bronco Brothers.....
I'm considering cutting off most of the rocker panels for more clearance and adding some rectangular steel tubing tied to the frame for rock protection...(Similar to the truck on the cover of the most recent Bronco Driver #32), I saw a thread somewhere recently where a guy tack welded a +-1" steel pipe behind the sheet metal, (tucked up tight to the underside of the floor), and used it to "roll" the bottom edge of the sheet metal to get a "radiused - stock" look verses a streight cut.....can't find the thread again....it had great pictures/directions......Has anyone else seen the thread or done this? Any advice?
THANK YOU.....Hank
(904) 237-7714
I'm considering cutting off most of the rocker panels for more clearance and adding some rectangular steel tubing tied to the frame for rock protection...(Similar to the truck on the cover of the most recent Bronco Driver #32), I saw a thread somewhere recently where a guy tack welded a +-1" steel pipe behind the sheet metal, (tucked up tight to the underside of the floor), and used it to "roll" the bottom edge of the sheet metal to get a "radiused - stock" look verses a streight cut.....can't find the thread again....it had great pictures/directions......Has anyone else seen the thread or done this? Any advice?
THANK YOU.....Hank
(904) 237-7714