Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Installing new Edelbrock intake & carb
#41
broncosbybart Wrote:that is one way to do it. can't believe you couldn't find a tee.

Lowes was a poor place to look to begin with. I found a 1/8 T at AutoZone so i got it. Got it home and realized I need an adaptor for all ends b/c all is 3/8 NP. I have a good size Tap & Die set that had a 3/8 NP tap. I used the correct drill bit and tapped it out. Cleaned out all the shavings, added lithium tape and installed everything. Here is a pic of it installed.


Attached Files Image(s)
   
[SIZE="2"]77 project bronco w/ 5.0 & c4, Sagi PS, 2 hard tops, eyebrow grill [/SIZE]
WANTED: auto column, gas tank, front/ rear seats
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)