Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
por 15
#1
wheres the best place to buy por 15?
Life is short------drive your bronco everyday!
Reply
#2
berg bronco Wrote:wheres the best place to buy por 15?

I know when I bought it form POR it was pretty expensive for shipping. I know that NPD does have it and shipping is not to bad plus you will get it in one day, that is if you place the order before 12:00.
Reply
#3
we have a couple hardware stores in town that stock it...one place in town had a lot more choices and more stock than all the others. i used POR15 silver on my frame(but i needed the UV protection coat) and i used POR20(header coating) both were awesome stuff
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.
Reply
#4
Chuck, how well did the POR20 coating hold up to the temp extremes (heat up, cool down cycles) that headers go through? Just wondering....Confusedcratchhe:
Mike Edwards....74 Bronco ($ Money Pit $)
Reply
#5
your supposed to put 3 coats on...but during my 1st build...i was itching to see how they looked on the motor(after one coat)...then never pulled them back off. just that one coat lasted about 2 years and was hell to blast off. those were the headers i used for a member give away. it came in a small can bout the size of Mother's Polish and was $30

if i can find it again, its all i will use
heres the pic of what it looked like...crappy pic tho

[Image: bronco1.jpg]
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.
Reply
#6
and heres one of the frame in silver
[Image: bronco6.jpg]
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.
Reply
#7
were they chain stores or local stores
Life is short------drive your bronco everyday!
Reply


Forum Jump:


Users browsing this thread: 3 Guest(s)