what have you wrenched on your bronco(s) today?

[chuzie]

Removed the windshield and the hood, cut out the driver's side floor pan, removed the gas pedal and clutch/ brake assembly. Then sat in the shell and made vroom noises. But I couldn't steer because it removed the steering column too :-)



Sent from my iPhone using Tapatalk

Fail! You can only make vroom noises whilst sitting upon a milk crate. All other attempts are null and void.

Sent from my GS3 on CyanogenMod with tapatalk2

[Earthguy]

Dang! Wish I'd known that before. I've wasted a good few month's with of vroom noises. Well, I'm off to find a crate. I have a lot of vroom to catch up on.


Sent from my iPad using Tapatalk

[jollygrngiant]

Thanks Bart, well the bronco is at my buds shop 2 hrs away and we have to fit it in after work so so trying to get it done : )
Your bronco is looking good lots of cool stuff going on with it. 👍😃

What a nice shop !! Looks like a airplane hanger.....wish I had that much space!! Lol!


Sent from my iPhone using Tapatalk

[scbronco]

removed two leafs from the rear leaf packs (for a total of four now...) i know it sounds bad, but it is still stiffer than i would like, we'll see if i get any axle wrap. Bronco does sit and ride much better now though.

built and installed a little speaker box to go up in the roll bar. got inside the t-case and freed up whatever was in a bind, so now i have front low range. installed a switch for my fuel guage. swapped on the halfcab since the softop leaks around the doors.

Now all i need to do before the meet n greet is install my wireless winch controller, top off t-case with gear oil, make a new rear fuel tank strap (exhaust interference), and maybe do a cherokee wiper mod...

[jac77]

What a nice shop !! Looks like a airplane hanger.....wish I had that much space!! Lol!


Sent from my iPhone using Tapatalk

Wish it was closer. But yes very cool shop it's one of 4 shops yes one of 4 and each one is at least that size if not bigger. At least a football field long

[broncosbybart]

If you have any shops near Charlotte you want to give away, I'll take it!

[jac77]

Ha ha wish it was mine to give away

[Bronco Biff]

Exhaust was getting a little rough............

[Bronco Biff]

Gibson hooked me up with some replacement in stainless!!! They make some nice stuff and the kit was spot on complete with nice new hangers and all!!

[scbronco]

removed the edelbrock fuel sump and shipped back out to edelbrock. sump over-pressurized on the trail at URE this weekend, and blew the sealed electrical connector out of the cover. they promised to send a new sump out, so i expect that in a couple of days. hopefully they get back with me on what went wrong with the original pump.