Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
cooling the EB
#21
Got the front clip all done, mounted alum radiator last night ...seems to sit a touch higher than stock. I think it do to the fact, this rad doesn't sit down in the rubber isolators, sits on top. So before going any further ...im gonna start 1"BL. I know ill have to lower rad then...so ill wait til BL is done then lower the rad correctly. As for hoses...doug left me the stock mustang hoses. I was able to use the upper for my top hose. Believe it or not, I was able to use dougs stock eb lower. Just flipped it and it went right on lower spot

Sent from my DROID BIONIC using Tapatalk 2
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.
Reply
#22
Fyi...on the upper mustang hose, I had to trim bout 1" off the radiator side and push like heck to get it on. The rad outlet is a lil bigger than hose

Sent from my DROID BIONIC using Tapatalk 2
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.
Reply
#23
aight...been super busy. as for cooling...i installed the alum radiator. spread the core supports open a little...might go for 4 core mounts later. i used the mustang upper and used the stock eb lower hoses. i used some 2x2 foam along the sides. so far i can get it past 160. a while back i installed a fail-safe 180*. i sure this hasnt failed while changing the rad. will watch it for a while.
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)