Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
What I've been up to lately...
#11
Very nice Jon!

MoMo
Reply
#12
Ouch. Kind of looks like the tranny fell off the jack too. That things weighs a ton. Hope your okay.
Just leave the torque convertor on until you get it out and on the ground.

[Image: img_0819.jpg]
Reply
#13
Worked on it a couple hours this afternoon. Got the clutch bled, the trans tunnel & carpet cut and the shifters reinstalled.

[Image: img_0874.jpg]
[Image: img_0878.jpg]
[Image: img_0879.jpg]


I couldn't resist these pedal pads, either :brownbag:
[Image: img_0876.jpg]
'95 Bronco -- 351W-435-205, D44 SAS, Cromos, Truetrac, E-Locker
Reply
#14
Very clean install! I like it. I'd love a clutch in the Bronco, but I'm not sure I'm up to the challenge when it comes to the trails.

MoMo
Reply
#15
I'm anxious to see how it does off-road, too. Heck, i'm anxious to see if it'll even crank up!!
'95 Bronco -- 351W-435-205, D44 SAS, Cromos, Truetrac, E-Locker
Reply
#16
looking sweet..you'll love the throttle response and gearing!!!!
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.
Reply
#17
Very clean job! Now you'll have to update us on the road test.
'74 Grocery Getter, '73 Project Buggy, '77 Parts Rig

[Image: Bannerpic.jpg]
Reply
#18
Wow! Looks like it went in pretty easy and made for a neat install. Like a factory install.

You know I didn't think about it till I saw your picture. But I have an extra manual trans cover plate from a 70's F series. Looks like they are the same.
'72 TBA...
Reply
#19
[SIZE="6"]IT RUNS!!!![/SIZE]


Bypassed the neutral safety switch by finding these 2 "Red & Lt. Blue" wires and jump a wire between them

[Image: img_0902.jpg]

[Image: img_0901.jpg]
'95 Bronco -- 351W-435-205, D44 SAS, Cromos, Truetrac, E-Locker
Reply
#20
just a sugestion pull the jump wire & use 1 of those 3m blue scotch locks between the 2 wires that way u can plug the harness back up......looks good though i dont want to shift gears anymore...left knee wont take it........:rebel:
SIZE MATTERS! :rebel: Uncle Ted [SIGPIC][/SIGPIC]
http://www.wheelindixie.com
http://www.coastalcarolinaoffroad.com
Reply


Forum Jump:


Users browsing this thread: 8 Guest(s)