|
Ford Dana 44 Question
|
08-12-2009, 07:17 AM
1979 F150 Dana 44 compared to 1990 Bronco Dana 44 TTB.
Will the Hub, Bearings, and Rotor work from the 90 axle on the 79 axle? Thanks, John Why you ask? Trying to save some money on a solid axle swap. 
08-12-2009, 09:25 AM
Those specific parts should swap over. The easy way to tell would be to go onto advance auto parts web site. Check the part numbers on the bearings and compare years. I'm sure the hub and rotors are the same, just never bothered to try the bearings.
[SIGPIC][/SIGPIC]
08-12-2009, 09:30 AM
ive seen them all swap over before. you are going to need differant calipers though.
|
|
« Next Oldest | Next Newest »
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| 1996 Ford Bronco- Body Bushing Install | jrshepherd | 2 | 2,411 |
09-19-2018, 02:50 PM Last Post: blazinchuck |
|
| 1977 Ford Bronco rear ended 9" rebuild | Crawdad | 10 | 5,167 |
01-19-2017, 12:53 PM Last Post: snipes243 |
|
| Steering shaft Extension Question??? | Broncitis | 4 | 2,866 |
04-17-2015, 02:27 PM Last Post: Broncitis |
|
| Exhaust question | Casey835 | 27 | 7,213 |
08-16-2013, 06:03 PM Last Post: blazinchuck |
|
| cummins to a ford small block standard trans adapter plate | Rdnckdemo | 2 | 1,244 |
04-14-2013, 01:19 AM Last Post: Rdnckdemo |
|
| Ford D.U.I. Ignition | scbronco | 14 | 8,030 |
09-06-2012, 06:03 PM Last Post: SC74 |
|
| dana 44 mods | 64500xl | 8 | 1,792 |
07-06-2012, 08:44 PM Last Post: chuzie |
|
| 1991 351W EFI Question | Crawdad | 4 | 2,096 |
03-27-2012, 09:05 AM Last Post: broncosbybart |
|
| Hard top Question | 744x4 | 5 | 4,199 |
09-06-2011, 10:32 PM Last Post: Mill Knob |
|
| Tire question | dixieboyz13 | 12 | 4,562 |
08-25-2011, 01:58 PM Last Post: ncsubronc |
|
