Project Snow Ball

[broncomatt]

I can snap a pic of what I am running, although I use the 3g insted of the stock alt.
I also dont have that other bracket. I use the 3 bolt and the adjuster bracket.
Will get one tonight for ya.

[broncomatt]

Here is what I am running, hope this helps.

[73Bronc]

I'm finally getting around to posting on update on project snowball. Needless to say the engine bay required many hours of prep before paint. After a minor overspray incident, I took no chances this time :hysterical:



Here a look at the results. I'm pretty happy with it, considered it had 37 years of grease and grime built up.



I finally solved the alternator bracket puzzle. Only a few more final touches and the 351 can return to its rightful place.



I also got the tranny back this week. It checked out fine so I'll planning to stick with it. Now that Summer vacations have slowed down, I'm hoping to get it rolling soon.
:toothy12:

[snipes243]

Looking great man

[JayT]

Very good! Keep up the progress!

[firefighter2134]

good work.

[73Bronc]

I made more progress this weekend. Many thanks to my Dad and brother-in-law for stepping up and participating in this week's episode of Broncomania upergrin:



The headers made for a very tight fit on the passenger side



We finally realized that it just wasn;t going with the headers on, so we removed the passenger side and it finally slipped down into place.



After quite a bit of hammering underneath, The passenger side headers we reinstalled.

Yes, as I suspected, I cannot close my hood. :banghead: Should I go with a new hood or think about the 2" body lift? cratchhe:

[berg bronco]

you dont have to paint the body lift

[73Bronc]

Could I do thy body lift? How tough a job is it?

[abunchofidiots]

If there weren't guys in the picture, I would consider this _norp_.