JunKeBluB2 Hydro-Assit

[JunKeBluB2]

First I don't know if this will work the B2 is still on jack stands. Used stock B2 pump don't Know if I'll have enough flow for box & the cylinder but here it is. Got the cylinder (2" x 8"), hydraulic lines (pre-made), & fittings from Tractor Supply everything else I had on hand. Cost of build about $150. And if any of you have hydro-assist & can tell me how to bleed the system it would really help out. Thanks in advance!
Ronnie

First pulled the box



Box Dissembled



Box drilled now tapping



Holes taped (upper right & bottom center of pic)



Ready for assy.



Box assembled hoses attached



DRilling out flow valve



Everything back in



Blocks welded to axle & tie rod. Cylinder in & lines attached





This is my filler neck extension for xtra fluid capacity used 2" x 1 1/2" reducing coupling turned 1 1/2" side to about .010 press fit into pump filler neck turned 2" side to clear air cond. lines used 6" of 2" pipe w/ threaded adapter & screw in plug w/ vent hole drilled in center









Now as I said don't know if it will work or not but to give credit where I got build info check out this link.

http://fullsizebronco.com/forum/showthre...eering+box