Chuzie's '77 Project

[chuzie]

Ok. Well I went ahead and did what I could with my own mechanical logic. After mixing and matching I go my endplay to .012 with a .119 #1 and a .072 #2.

Since I only had one gasket I didn't want to jack it up playing around with the different washers so I did not have it installed with my initial measurements and that threw them off so make sure you take that into account if you do it that way.

So I buttoned up the pump and stator and installed the modulator and the governor as well as accomplished the air checks. All the air check s were fine but I was a little concerned that the air check for the governor produced odd results and this is why. You are supposed to run air from the governor outlet port and it is supposed to dither but even with high psi it did nothing except vent air through the inlet port. It was not until I plugged the inlet port that the dithering occurred. So this tells me the valves are moving but I am worried that something may be wrong since I had to plug the inlet to get it to work. Any thoughts?