12-09-2007, 02:25 PM
I havent had much time to work on my projects. I did make a trip to a local wheeling hole, no breakage.
Spent a ton of cash on more stuff for my work shop, and have spent the last few weekends working on it.
The one good thing I have gotten done was tear in to my full size.
It realy is very clean, very little rust by my standers.
Pulled the rear mat, changed the drivers door pannel,pulled trany pan.
I plan to get the oil pan down this week. It has a car pan.
Some where I have a mini spool for it.
The engin is also going to get some work, just dont know if I want too hop it up too much. Gas cost too much. My crew cab is simply on hold untill bills are cought up. Just not much sence on finishing it up when I couldent even afford to drive it around much.
Hope you all have a mery xmass.
Broncomatt
Spent a ton of cash on more stuff for my work shop, and have spent the last few weekends working on it.
The one good thing I have gotten done was tear in to my full size.
It realy is very clean, very little rust by my standers.
Pulled the rear mat, changed the drivers door pannel,pulled trany pan.
I plan to get the oil pan down this week. It has a car pan.
Some where I have a mini spool for it.
The engin is also going to get some work, just dont know if I want too hop it up too much. Gas cost too much. My crew cab is simply on hold untill bills are cought up. Just not much sence on finishing it up when I couldent even afford to drive it around much.
Hope you all have a mery xmass.
Broncomatt
[SIGPIC][/SIGPIC]