06-29-2011, 05:33 PM
back when FBG was new'ish looking...I installed a deeper TCI pan(maybe from Summit), I had to drill the hole for the dip stick tube, then install a bulkhead fitting for the tube. If I recall, there was a machined spot for adding a temp gauge...but that meant you would have to drill and tap it for 1/8NPT. the pan temp location would look cleaner, but i think the temp for fluid going to the rad would the be the hottest...I know summit sells a inline "T" for plumbing a temp gauge between the trans and rad.
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.