12-08-2011, 03:45 PM
Thx guys! I have a new rebuild kit for front and rear when I change gears. I prolly wont do that till I get back next summer. A C4 + 4.56s + 33s = high rpms so I will wait a while till I find a 4 spd tranny. I doubt I will drive it very much before I leave so I will re-use whatever falls out. If I come across a bearing (w/o having to ruin a seal) I will repack it. I may use the press at Drill next weekend, unless I find one sooner.
So the inner nut 50 ftlb, back off 45-90 degrees. Then 160-205 on outer locknut w/o backing off. Then the two steps for the adjusting nut. I'll play with it tomorrow.
So the inner nut 50 ftlb, back off 45-90 degrees. Then 160-205 on outer locknut w/o backing off. Then the two steps for the adjusting nut. I'll play with it tomorrow.
[SIZE="2"]77 project bronco w/ 5.0 & c4, Sagi PS, 2 hard tops, eyebrow grill [/SIZE]
WANTED: auto column, gas tank, front/ rear seats
WANTED: auto column, gas tank, front/ rear seats