Carolina Broncos › 66-96 Ford Broncos › Bronco Tech v
Replacing a lub bolt stud on rotor

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Replacing a lub bolt stud on rotor
broncosbybart Offline
Moderator
*****
Posts: 3,290
Threads: 141
Joined: Dec 2007
Reputation: 0
#11
12-08-2011, 05:20 PM
That is some awfully high torque for the locking nut. You'll be hard pressed to get that without the tool wanting to walk off of the locking nut. I usually tighten them 'lug nut' tight. You will be able to repack the outer bearing but not the inner. Clean the bearing really good to check for pitting or scoring.
Find
Reply


Messages In This Thread
Replacing a lub bolt stud on rotor - by Crawdad - 12-08-2011, 11:22 AM
Replacing a lub bolt stud on rotor - by Crawdad - 12-08-2011, 12:20 PM
Replacing a lub bolt stud on rotor - by SC74 - 12-08-2011, 01:44 PM
Replacing a lub bolt stud on rotor - by Crawdad - 12-08-2011, 03:45 PM
Replacing a lub bolt stud on rotor - by JayT - 12-08-2011, 04:15 PM
Replacing a lub bolt stud on rotor - by broncosbybart - 12-08-2011, 05:20 PM
Replacing a lub bolt stud on rotor - by Casey835 - 12-10-2011, 12:24 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  8.8 Cross Pin bolt damage JayT 15 4,005 08-08-2014, 10:55 AM
Last Post: Bronco Biff
  broken thermostat housing bolt dixieboyz13 13 2,578 02-07-2012, 09:31 PM
Last Post: dixieboyz13
  Hub/ Rotor questions Crawdad 2 1,912 01-31-2012, 09:46 PM
Last Post: Crawdad
  Replacing rear main seal mannyjmf 6 1,458 10-15-2008, 08:53 PM
Last Post: mannyjmf

Forum Jump:


Users browsing this thread: 1 Guest(s)