08-03-2014, 08:14 PM
(This post was last modified: 08-03-2014, 08:16 PM by broncosbybart.)
You about have it except you will need to grind down the spot welds on the old floors before you try and separate them from the cross member. You can't just air chisel them apart without destroying the cross member. You basically have to grind through the floor pan, but not into the crossmember. Then use an air chisel as needed. Make sense?
When you've done it a few times you don't really need to locate the cross member first. Just helps sometimes. Biggest thing is to not just go crazy cutting things and cut a crossmember. I've seen it done.
When you've done it a few times you don't really need to locate the cross member first. Just helps sometimes. Biggest thing is to not just go crazy cutting things and cut a crossmember. I've seen it done.