New Project started today

[NGABronco]

Now Keith, you're not going to end up with a rig like this are ya'!!!!!LOL I had to do that!!!
How's your knee doing????

[744x4]

Not quite that severe but it will be smaller/narrower on the 105 in WB chassis.Although the Chassis is cut off @ the rear spring hangers so there is less overhang out back.

[SC74]

Looks like you got the lower body line out nicely too.

[744x4]

It blended in really Good.Now to do the other side this weekend and then start narrowing it and replacing the Floors also.I have 3 more weeks off work so we will see how far I get before then.

[SC74]

Post some pics up! A few Budweiser's later one side is off and 4-1/2" is chopped!

[744x4]

Yeah Robert came over today with 1 thing in Mind and that was to rid the Bronco of some width so we did the Pasengers side.4.5 inches is alot on the Pasenger side to trim. Now to put the 1 1/4 in L stock in place and Button up the side and call it good.

[SC74]

All I have to say is.....




Keith + 3 more weeks of short term disability = mad progress on the bruggy! He got a lot done today and I helped finish the day by getting the windshield frame off.

[744x4]

Robert came over after work and wanted to get the windshield frame off .I already had made the 1 1/14 perimiter angle iron for the pasengers side frame and welded the whole side back on then proceeded to cut the drivers side off.Damn the pasengers side will be skinny as there is only 11.5 in of Floor Left.We fixed his Uncle's JD Mower then went to town on the Drivers side so it wont take mutch to put it back on tomorrow.

[744x4]

More pictures.I forgot to weld a few things so I will go back over Both sides tomorrow.

[broncosbybart]

so i guess you decided not to stretch the body and are doing a truggy kinda thing???