08-02-2009, 06:16 PM
You are putting in a new turn signal switch right?
The new switch has the switch, wires and connector?
This tool helps get the pins out of the connector plug without destroying anything.
Your new turn signal switch should have the switch, wires and a connector plug.
1. You remove the new connector plug using the pin removal tool.
2. Snake the wires from the top of the collum down.
3. Re-connect all the pins to the connector plug. (in the right spots!)
4. Plug it in to the main harness and your ready to put everything back together.
The new switch has the switch, wires and connector?
This tool helps get the pins out of the connector plug without destroying anything.
Your new turn signal switch should have the switch, wires and a connector plug.
1. You remove the new connector plug using the pin removal tool.
2. Snake the wires from the top of the collum down.
3. Re-connect all the pins to the connector plug. (in the right spots!)
4. Plug it in to the main harness and your ready to put everything back together.