10-21-2009, 10:09 AM
Matt is a very knowledgeable dude. We talked for a while and he gave me some suggestions to try and narrow down the problem.
He had me adjust the rears almost all the way out and extend the pushrod a little further. Then I jacked the truck up on stands to see if the brakes would hold the wheels under a load. They don't.
Initially when I place it into drive with the brakes fully applied I get a hair of movement from the rear. Then when i do some power braking the rears spin. I also tried it in 4-low and all four tires would spin, with resistance of course.
I think he is concerned about the master cylinder at this point. Waiting to hear back from him today.
He had me adjust the rears almost all the way out and extend the pushrod a little further. Then I jacked the truck up on stands to see if the brakes would hold the wheels under a load. They don't.
Initially when I place it into drive with the brakes fully applied I get a hair of movement from the rear. Then when i do some power braking the rears spin. I also tried it in 4-low and all four tires would spin, with resistance of course.
I think he is concerned about the master cylinder at this point. Waiting to hear back from him today.
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.
mokin:
Roads? Where we're going, we don't need roads.
![[Image: sig2.jpg]](http://i288.photobucket.com/albums/ll176/mchuzie/sig2.jpg)
mokin:Roads? Where we're going, we don't need roads.