10-27-2009, 10:03 PM
The bronco tech manual states the pin on the prop valve should be pulled when bleeding the brakes to allow fluid to the front calipers without a pressure load.
Procedure....
Top off reservoir.
Start at RR
Install clear bleeder hose and place fluid catch above valve level.
Loosen valve 1/4 turn.
Pump brake pedal slowly until no air present in bleeder hose.
Tighten valve.
Remove bleeder hose and fluid catch.
Drain fluid catch.
Refill reservoir.
Repeat on LR-RF-LF
Repeat process 3 add'l times starting with RR
Procedure....
Top off reservoir.
Start at RR
Install clear bleeder hose and place fluid catch above valve level.
Loosen valve 1/4 turn.
Pump brake pedal slowly until no air present in bleeder hose.
Tighten valve.
Remove bleeder hose and fluid catch.
Drain fluid catch.
Refill reservoir.
Repeat on LR-RF-LF
Repeat process 3 add'l times starting with RR
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.mokin:
Roads? Where we're going, we don't need roads.
Roads? Where we're going, we don't need roads.