Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Chain Drive vs. Gear Drive
#4
I know that the gear drive is old school technology. I kinda dig that gear whine noise that it makes. They do make a quiet version but it is just quieter, not silent. I was shopping Summit and found some fairly cheap double rollers, that look very enticing. WHOA!:rubeyes: the Jesel belt drive systems are way out of my budget $1100.
I am leaning towards the double roller just becuase of the cheaper price, but like I said the gear drive just sounds cool IMO.
And I didn't forget about the thermostat, it was replaced last summer.:xyxthumbs: Thanks for the input y'all.:xyxthumbs:
Reply


Messages In This Thread
Chain Drive vs. Gear Drive - by BucknEB - 03-04-2011, 04:35 PM
Chain Drive vs. Gear Drive - by bucketobolts - 03-05-2011, 03:06 AM
Chain Drive vs. Gear Drive - by broncosbybart - 03-05-2011, 11:21 PM
Chain Drive vs. Gear Drive - by BucknEB - 03-08-2011, 11:37 AM
Chain Drive vs. Gear Drive - by Mill Knob - 03-09-2011, 11:30 PM
Chain Drive vs. Gear Drive - by BucknEB - 03-10-2011, 02:12 PM
Chain Drive vs. Gear Drive - by bucketobolts - 03-10-2011, 04:22 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  77 EB Rear Drive Shaft Dropped - Second time in six months UTFLIWGYA 4 2,034 12-01-2013, 10:38 PM
Last Post: broncomatt
  ***9" Axle Gurus...Ring gear dug into pilot housing!** chuzie 7 2,444 12-05-2012, 12:35 AM
Last Post: chuzie
  Axle / Gear gurus help!! SC74 4 2,451 03-28-2012, 08:52 AM
Last Post: SC74
  USA Standard Gear? SC74 2 1,329 03-09-2012, 09:51 PM
Last Post: blazinchuck
  Precision Gear vs Yukon? JayT 15 4,632 10-26-2009, 09:30 AM
Last Post: JayT
  Determine gear ratio chuzie 17 8,374 07-13-2009, 10:15 PM
Last Post: bucketobolts
  Gear Ratio??? BroncJr 9 4,879 03-31-2008, 08:17 PM
Last Post: chuzie
  Gear Reduction Starter johnpaulgolf 4 2,690 02-28-2008, 04:03 AM
Last Post: broncomatt
  oil pump drive broncomatt 3 1,230 01-10-2008, 03:20 PM
Last Post: broncomatt

Forum Jump:


Users browsing this thread: 2 Guest(s)