Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Another Fine 69
#31
I dont have any pics on this but I asked questions about it. I had one guy say they didnt have to be cut out and everybody else said cut them out. I prbly gonna cut them out because it would definately offer more room.
Reply
#32
well i got engine dropped in yesterday evening...slid in like butter... now to do radiator mounts and tcase and tranny. then fire it up


Attached Files Image(s)
               
If you can't fix it with a hammer and a welder then your gonna need a new one!
Reply
#33
can someone take a pic of their radiator mounts. and hangers. im ready to weld mine in. just wanna make sure i get them right. thanks.
If you can't fix it with a hammer and a welder then your gonna need a new one!
Reply
#34
ok just finished up the modified shifter linkage for floor shifter. since i had to customize it for the 6 cyl i ended up remodifiying it for v8.. it shifts good outside bronco hopefully will work great inside..


Attached Files Image(s)
   
If you can't fix it with a hammer and a welder then your gonna need a new one!
Reply
#35
Sorry if I missed it, what tranny are you using? It lokks like a 3 sp but I guess the adapter is throwing me off! Then again not sure. Been meaning to ask where how you placed your motor stands. Did you do the 9 inch back from the cross member. If so dies that apply to the side of the stand or center. The diagram I have looks like the center.
Reply
#36
its a rat 3spd. the motor stands are 11 inches from edge of cross member to center of the hole on motor towers. thats where the directions said to put them. i ordered them from toms. i hope to get radiator mounted tomorrow. and hopefully can drive it around the yard this weekend. thats what im shooting for but we will see.
If you can't fix it with a hammer and a welder then your gonna need a new one!
Reply
#37
looking good, but i thought you were going with a 435?? besure to video the main voyage lol
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.
Reply
#38
i do plan on going with np435 at some point. but wifey wanted new furniture so that cut into project. so the 435 will have to wait..lol
ordered clutch bell crank and adjusting rod. so the maiden voyage will have to wait till those come in. i hope to have everything else done waiting on those parts to get here. shooting for wednesday. and video will be a must..im gonna have to learn how to drive it with the skinny pedal...
If you can't fix it with a hammer and a welder then your gonna need a new one!
Reply
#39
:drinkbud:tranny and t case are in! not much left to do now...then will have the maiden voyage!!:drinkbud:
If you can't fix it with a hammer and a welder then your gonna need a new one!
Reply
#40
radiator mounts are in and radiator in. on to driveshafts and shifters.. and still waiting on clutch linkage...


Attached Files Image(s)
           
If you can't fix it with a hammer and a welder then your gonna need a new one!
Reply


Forum Jump:


Users browsing this thread: 29 Guest(s)