Posts: 1,252
Threads: 77
Joined: Nov 2010
Reputation:
0
I bought Sun Pro guages and I was wondering where some of you all installed your oil pressure line to the engine block. The instructions were not very helpful. I have an oil pressure sending extention with the oil pressure sending unit at the end with the wire attached at the end. Simple enuff huh?? Do I need to tap the extention tube??? Any advice would be great! Thx!
[SIZE="2"]77 project bronco w/ 5.0 & c4, Sagi PS, 2 hard tops, eyebrow grill [/SIZE]
WANTED: auto column, gas tank, front/ rear seats
Posts: 1,319
Threads: 42
Joined: Oct 2006
Reputation:
0
Just remove the sending unit and install your pressure line. Should be simple enough. The wire and sender will not be needed with the use of the mechanical gauge.
'72 TBA...
Posts: 965
Threads: 53
Joined: Nov 2009
Reputation:
0
when i done mine i opted for the copper tubing upgrade for 10 bucks. well worth it because the plastic line that comes with the guages is crap imho. but i took the factory sender off and installed the pcs from the kit into the extension.
If you can't fix it with a hammer and a welder then your gonna need a new one!
Posts: 6,190
Threads: 511
Joined: Oct 2005
Reputation:
0
i posted on your other thread....buy a brass tee and run both...simple
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.
