04-14-2009, 10:13 PM
66stocker Wrote:Hey George,
OK ... the dial face comes off the radio seperate from the chassis.
In the blurry pic (sorry) there are 2 screws to the outside of the knob pins.
These screws go through the dial face and into the plate that says top and front in the second pic.
The radio chassis is held in by nuts on the knob pins and one screw in the bottom of the dash.
You can see in the third pic the stock holes in the dash. If you have a big old hole in your dash it looks like you are going to have to get creative to mount yor dial face unless you have the plate in the second pic.
Hope this helps and good luck!
Bill
Bill that Help me out alot I do mean a lot.:biggthumpup: So did you go home and take it apart? If so thanks alot. So are you still going over the the Bronco show in Tn ? If so the I will see you there on Saturday.:drinkbud: