06-17-2009, 12:52 PM
Since your reinstalling the original axles and reusing the original center chuck I would say there are two possibiltys.
1 they gave you the incorrect bearings (measure the old ones to compare how wide).
2 the center section is a posi and to install the shafts you must enguage the first set of splines then turn the axle shaft untill they spline with the inner coller.
Those bearings press all the way on untill they stop. There should be a raised lip they hit when there done being pressed on.
If your problems still occure, take some pics and post them up. That will help.
Broncomatt
1 they gave you the incorrect bearings (measure the old ones to compare how wide).
2 the center section is a posi and to install the shafts you must enguage the first set of splines then turn the axle shaft untill they spline with the inner coller.
Those bearings press all the way on untill they stop. There should be a raised lip they hit when there done being pressed on.
If your problems still occure, take some pics and post them up. That will help.
Broncomatt
[SIGPIC][/SIGPIC]