10-24-2009, 10:59 PM
I ended up getting USA Standard, from JBG, because they didnt' have Precision's in 4.10s... I started putting them in today... and very quickly understood why shops charge over 500 bucks to install gears! I wish the Chuck and Moody show was closer, because I'd gladly pay 200 bucks to have these gears done today!
This is my first gear install (big surprise), so I'm learning as I go. I found (what I think is) a damn good writeup on pirate... and trying my best to follow it. I didn't have all the tools (dial indicator & mic) to begin with... I also found that setup bearings are a MUST! Thankfully, my old ones were salvageable for this use. I'm lacking an outer pinion setup bearing, so the install will continue this week... Here's hoping...
JayT
This is my first gear install (big surprise), so I'm learning as I go. I found (what I think is) a damn good writeup on pirate... and trying my best to follow it. I didn't have all the tools (dial indicator & mic) to begin with... I also found that setup bearings are a MUST! Thankfully, my old ones were salvageable for this use. I'm lacking an outer pinion setup bearing, so the install will continue this week... Here's hoping...
JayT