12-06-2010, 12:48 AM
(This post was last modified: 12-06-2010, 01:18 AM by broncosbybart.)
Friday I scored a set of 33" TSL's with between 1/2 and 3/4 tread in exchange for a used soft top for a HEEP.
![[Image: P1010017.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/P1010017.jpg)
Here is my junkyard donor engine. It looks like we have the green light to run EFI, so we will be using all that. The truck I pulled it from was hit in the side and practically bent in a U. Took the trans and wiring harness as well, but I think I will end up going with the original C-4 and a EEC-IV computer setup like found in the 89-93 MAF Mustangs.
![[Image: P1010015.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/P1010015.jpg)
Next up we have the tub and 1/2 of the frame. I am going to have to piece a frame together. Don't have a good one to start with at this point. Some of you might remember where this tub came from.
![[Image: P1010019.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/P1010019.jpg)
It will be getting a full 1.75x.120 wall DOM roll cage tied into some 2x4 rock skis which will be tied directly into the frame rails.
![[Image: P1010017.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/P1010017.jpg)
Here is my junkyard donor engine. It looks like we have the green light to run EFI, so we will be using all that. The truck I pulled it from was hit in the side and practically bent in a U. Took the trans and wiring harness as well, but I think I will end up going with the original C-4 and a EEC-IV computer setup like found in the 89-93 MAF Mustangs.
![[Image: P1010015.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/P1010015.jpg)
Next up we have the tub and 1/2 of the frame. I am going to have to piece a frame together. Don't have a good one to start with at this point. Some of you might remember where this tub came from.
![[Image: P1010019.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/P1010019.jpg)
It will be getting a full 1.75x.120 wall DOM roll cage tied into some 2x4 rock skis which will be tied directly into the frame rails.