02-06-2011, 12:52 AM
Next, new Wild Horses spindle bushings were pressed in.
Assembled the knuckes, new ball joints, and greased the axle shaft joints.
Next, Clay fabbed up some DOM to use for a new rear crossmember. I welded it in place then he cut out the original crossmember, as it was going to be in the way of the rear axle (it is going to be moved 4" toward the rear).
Assembled the knuckes, new ball joints, and greased the axle shaft joints.
Next, Clay fabbed up some DOM to use for a new rear crossmember. I welded it in place then he cut out the original crossmember, as it was going to be in the way of the rear axle (it is going to be moved 4" toward the rear).