02-11-2011, 09:06 PM
To clarify, the plates that I made were welded to the upper track bar mount. Basically just thickened what was there already. I did do a lot of welding on it as well.
Next was a quick coat of paint to keep it all clean. I can grind paint off and weld things on as needed but now I don't have to worry about anything rusting up. Almost all the hardware going into it is grade 8.
Now I am working on fabbing up some extreme motor mounts. I had the lower pieces but not the uppers. Making the uppers now out of flat plate and angle iron.
Next was a quick coat of paint to keep it all clean. I can grind paint off and weld things on as needed but now I don't have to worry about anything rusting up. Almost all the hardware going into it is grade 8.
Now I am working on fabbing up some extreme motor mounts. I had the lower pieces but not the uppers. Making the uppers now out of flat plate and angle iron.