02-14-2011, 12:57 AM
Clay cut the mounts out of cardboard and then transferred everything over to metal. Nick did a lot of the cleaning and finishing on them while I ran brake lines.
Here is a pic of the traction bar. It sits kind of low to hopefully protect the drive shaft from oncoming rocks, trees, stumps, and run-over Jeeps...
![[Image: P1010022.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/Traction%20Bar/P1010022.jpg)
Here is a pic of the traction bar. It sits kind of low to hopefully protect the drive shaft from oncoming rocks, trees, stumps, and run-over Jeeps...
![[Image: P1010022.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/Traction%20Bar/P1010022.jpg)
![[Image: P1010021.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/Traction%20Bar/P1010021.jpg)