03-04-2011, 12:05 AM
Fabbed up some bump stop mounts. Used 1.5x3" rectangle. Welded nuts on the inside, then capped the tube and welded it to the bottom of the frame. I wanted to get the bump stops a little closer to the rear axle. I will be using 2x2 square tube on the front to raise the bump stops on the front axle.
![[Image: ShockMounts012.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/Shock%20Mounts/ShockMounts012.jpg)
![[Image: ShockMounts014.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/Shock%20Mounts/ShockMounts014.jpg)
![[Image: ShockMounts012.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/Shock%20Mounts/ShockMounts012.jpg)
![[Image: ShockMounts014.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/Shock%20Mounts/ShockMounts014.jpg)
![[Image: ShockMounts019.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/Shock%20Mounts/ShockMounts019.jpg)