03-22-2011, 10:26 PM
Been bad about taking pics lately. Here are some of the latest things going on with it:
The traction bar crossmember was drilled and tapped into the thin walled frame. I decided that wouldn't suffice. So, out came the plasma cutter, some DOM and the welder. I cut holes in the frame to bush it solid with some 1/2 ID DOM. Then I fit it all in there, and welded it all up and ground it all smooth again. Turned out great. The crossmember will not go anywhere now!!
![[Image: Tractionbar1.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/Headlight%20Misc%20Fab/Tractionbar1.jpg)
Tacked in place:
![[Image: tractionbar2.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/Headlight%20Misc%20Fab/tractionbar2.jpg)
All welded up:
The traction bar crossmember was drilled and tapped into the thin walled frame. I decided that wouldn't suffice. So, out came the plasma cutter, some DOM and the welder. I cut holes in the frame to bush it solid with some 1/2 ID DOM. Then I fit it all in there, and welded it all up and ground it all smooth again. Turned out great. The crossmember will not go anywhere now!!
![[Image: Tractionbar1.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/Headlight%20Misc%20Fab/Tractionbar1.jpg)
Tacked in place:
![[Image: tractionbar2.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/Headlight%20Misc%20Fab/tractionbar2.jpg)
All welded up:
![[Image: tractionbar4.jpg]](http://i786.photobucket.com/albums/yy147/broncosbybart/ECORS%20Racer%20Parts%20Gathering/Headlight%20Misc%20Fab/tractionbar4.jpg)