10-22-2011, 11:27 PM
Been working on it, but slack on updating. Got the front end done. New gears are 4.88's. Something screwed me up with my gear setup and I had next to no backlash after I pressed the carrier bearings on. Had to carefully pull them back off and change some shims. I made my own setup bearings from an old set and they work well. Not sure what happened, but it was annoying.
Very happy with how the OX turned out. Hopefully it will work as good.
While I was at it, I cleaned and repacked the hubs, beairngs, lockouts, and spindle bearings. Greased the axle shafts and the ball joints as well.
Very happy with how the OX turned out. Hopefully it will work as good.
While I was at it, I cleaned and repacked the hubs, beairngs, lockouts, and spindle bearings. Greased the axle shafts and the ball joints as well.