Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
90 Bronco TTB Yoke Question
#1
Ok, I have a yoke question:

We are starting our SAS on a 90 Bronco and will be installing a 79 F150 Dana 44. Before I have the gears installed I would like to get the right yoke and since i'm selling the TTB I can't remove the original yoke. What are the specification difference between:

1310 yoke?
1330 yoke?
1350 yoke?

If this has already been addressed please provide link, I could not find anything.

Thanks
Reply
#2
if you have a 1979 hp44 then your yoke is a 1330
1978 and older was 1310.
the slip yoke from your bronco is more than likely a 1330 and will fit right up to the yoke on your 79 dana 44.
East Coast Surplus & Tactical
336-674-3868
Reply
#3
oh and if you need any yokes or slip yokes or driveshaft tubes , pm me. i still have a stack of them.
East Coast Surplus & Tactical
336-674-3868
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  1996 Ford Bronco- Body Bushing Install jrshepherd 2 2,380 09-19-2018, 02:50 PM
Last Post: blazinchuck
  Stainless/ Coated Headers needed- 1995 Bronco 351 Windsor .20 over trick flow heads jrshepherd 1 3,215 05-22-2018, 09:38 PM
Last Post: broncosbybart
  1977 Ford Bronco rear ended 9" rebuild Crawdad 10 5,096 01-19-2017, 12:53 PM
Last Post: snipes243
  BC Bronco Soft Top knoxville714 3 3,108 07-12-2016, 08:04 PM
Last Post: blazinchuck
  1996 Bronco New BSD 4" long arm lift on IFS suspension- Setting Wheelbase jrshepherd 11 3,756 01-31-2016, 03:55 PM
Last Post: broncosbybart
  Steering shaft Extension Question??? Broncitis 4 2,845 04-17-2015, 02:27 PM
Last Post: Broncitis
  Another Bronco Floor Replacement jdowns67 83 14,139 12-20-2014, 11:33 AM
Last Post: jdowns67
  Exhaust question Casey835 27 7,133 08-16-2013, 06:03 PM
Last Post: blazinchuck
  Mystery Bronco, need your expertise to solve 1st Bronco 2 2,863 08-04-2013, 10:48 PM
Last Post: 1st Bronco
  OK. I love my Bronco again Timstrk 3 2,497 05-19-2013, 08:43 PM
Last Post: chuzie

Forum Jump:


Users browsing this thread: 2 Guest(s)