|
bushing install ?
|
08-11-2011, 07:19 PM
is it gonna be easier to pull front axle to install the 14 pc bushing kit? the instructions that came with the kit from duffs says to do one side at a time.
If you can't fix it with a hammer and a welder then your gonna need a new one!
08-11-2011, 09:56 PM
firefighter2134 Wrote:is it gonna be easier to pull front axle to install the 14 pc bushing kit? the instructions that came with the kit from duffs says to do one side at a time. I did one side at a time, also took pics as I went along just in case. The radius arm bushing can be a pain. When you replace those u may need to do an alignment. When the arm is off its a good time to clean it up and paint!
[SIZE="2"]77 project bronco w/ 5.0 & c4, Sagi PS, 2 hard tops, eyebrow grill [/SIZE]
WANTED: auto column, gas tank, front/ rear seats
08-11-2011, 10:30 PM
I thought the same so just gonna pull whole thing clean and paint it and since its out gonna weld up carrier
If you can't fix it with a hammer and a welder then your gonna need a new one!
|
|
« Next Oldest | Next Newest »
|
