12-06-2008, 10:29 AM
is it hard to install new axle pivot bushings? i've been told that you need to disassemble the whole front suspension. then i heard that you don't need to. so which one is correct?
|
axle pivot bushings
|
12-08-2008, 06:44 PM
Although I haven't had to do it *yet*, it doesn't seem to be too bad if you have the "right" tools... Check out the how-to article on FSB... http://www.fullsizebronco.com/forum/show...hp?t=65881
Let me know how it goes and take some pics and post up your own how-to here and we'll sticky it! Thanks, JayT 
12-09-2008, 06:46 PM
i will try not to forget to take some pics. thanks for the info.
12-09-2008, 11:51 PM
Not too bad at all, If you have a winch or a high lift its really easy. I prefer the rubber bushings with the pree load. Rubber is much quieter and seems to ride nicer.
Broncomatt |
|
« Next Oldest | Next Newest »
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Pitman arm bushings? and a couple other suspension ?'s | knoxville714 | 3 | 3,162 |
09-16-2016, 08:10 AM Last Post: Deltabronco |
|
| C- Wedge bushings | snipes243 | 25 | 7,344 |
08-14-2015, 12:01 AM Last Post: chuzie |
|
| Axle Tube Vents | Casey835 | 4 | 1,427 |
03-01-2013, 08:20 PM Last Post: Casey835 |
|
| ***9" Axle Gurus...Ring gear dug into pilot housing!** | chuzie | 7 | 2,444 |
12-05-2012, 12:35 AM Last Post: chuzie |
|
| Axle / Gear gurus help!! | SC74 | 4 | 2,454 |
03-28-2012, 08:52 AM Last Post: SC74 |
|
| F150 axle shaft tech | blazinchuck | 12 | 3,128 |
12-03-2011, 09:34 PM Last Post: broncosbybart |
|
| Stuck rear axle? (9") | Action | 6 | 1,551 |
06-24-2011, 09:42 PM Last Post: jollygrngiant |
|
| rear axle shims? | berg bronco | 15 | 2,513 |
01-04-2011, 09:52 PM Last Post: blazinchuck |
|
| axle | bluebooger | 6 | 1,406 |
12-02-2010, 12:45 AM Last Post: broncosbybart |
|
| Axle Seal Leak.. Again! | 73Bronc | 13 | 3,342 |
10-15-2010, 01:50 PM Last Post: chuzie |
|
Users browsing this thread: 1 Guest(s)