Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
stock rear drums
#1
3 weeks ago, I noticed the pass rear tire had brake fluid running down the back side of it. figured the wheel cylinder was shot so I replaced both rear cylinders. truck stopped beautifully and quit leaking. yesterday I notice its leaking again. what gives? brand new cylinders. same side that was leaking before is leaking now, at the same rate. im no drum expert, so what am I missing?
My Build Thread-
http://www.carolinabroncos.com/forums/sh...php?t=3919

You're gonna have to be more specific... 11/12/11
Reply
#2
Confusedupergrin:Missing disk brakes
68 Half cab
Reply
#3
buy me some! otherwise... any realistic suggestions? LOL
My Build Thread-
http://www.carolinabroncos.com/forums/sh...php?t=3919

You're gonna have to be more specific... 11/12/11
Reply
#4
maybe the shoes are so worn out that the wheel cylinder is over extending??
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.
Reply
#5
blazinchuck Wrote:maybe the shoes are so worn out that the wheel cylinder is over extending??

I guess that's a possibility... they sure seem to have a lot of meat left on em tho... ill replace em...
My Build Thread-
http://www.carolinabroncos.com/forums/sh...php?t=3919

You're gonna have to be more specific... 11/12/11
Reply
#6
You sure it's not an axle seal leak?
Reply
#7
no need in replacing them if they look good.
77 built 306,Trickflow Cam/Alum Heads/dome pistons/10:1comp,nv3550,duff long arms,3.5" lift,family cage,protofab rear bumper,twin sticked, and 35KM2'sG.D.I.
Reply
#8
measure the inside of the drum as well, it could be too worn out and too big even for new shoes.
'73 Bronco - trail modified
Reply
#9
The rear wheel cylinders use little 'extension rods' from each piston to the brake shoes. If one or both of them is missing, the pistons in the cylinder will overextend and leak severely/dangerous. Only other thing I could think of would be drum size. EB's used both 10" and 11" dia drums. Are they mis-matched? Net effect would be the same scenario as well. The 11" drums were narrower, so I think that'd be hard to screw up without noticing.

Let us know what you find.
Reply
#10
all the extension rods are there... i'll have to look at it tonight or tomorrow. I intended to last night, but the weather went south. thanks for the advice!
My Build Thread-
http://www.carolinabroncos.com/forums/sh...php?t=3919

You're gonna have to be more specific... 11/12/11
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  1977 Ford Bronco rear ended 9" rebuild Crawdad 10 4,802 01-19-2017, 12:53 PM
Last Post: snipes243
  Rebuilding used rear leaf springs Crawdad 5 4,094 12-12-2016, 11:54 AM
Last Post: Crawdad
  Lighted rear view mirror chuzie 6 4,476 06-20-2015, 12:18 AM
Last Post: chuzie
  rear main seal snipes243 5 2,853 05-03-2014, 11:45 AM
Last Post: chuzie
  Late 70s Cadi rear disc brakes for 77 banjo rear end Crawdad 11 3,619 01-11-2014, 12:26 AM
Last Post: Crawdad
  77 EB Rear Drive Shaft Dropped - Second time in six months UTFLIWGYA 4 1,914 12-01-2013, 10:38 PM
Last Post: broncomatt
  Grinding sound from rear end area when driving Crawdad 10 4,283 02-09-2013, 09:33 PM
Last Post: blazinchuck
  '94 351 Rear Main replacement JayT 5 1,520 12-22-2012, 05:34 PM
Last Post: JayT
  5.0 rear main bearing... is it going out??? chuzie 16 3,629 12-18-2012, 04:52 PM
Last Post: chuzie
  Efi and stock fuel tank snipes243 3 1,275 12-11-2012, 03:28 PM
Last Post: Carolinaoffroad

Forum Jump:


Users browsing this thread: 2 Guest(s)