02-14-2011, 12:50 AM
(This post was last modified: 02-14-2011, 12:54 AM by broncosbybart.)
A big thanks for Nick H. and Clay for their time this weekend. Nick is going to be working on the wiring harness for the EFI motor. He came all the way down from the High Point area and spent the day working on Sat. This wouldn't be possible without all the help from the CB4x4 community!!!
Got the engine in as well as a makeshift 3 spd and t-case. Waiting on the automatic trans to be done.
Clay using some hi tech tape to mark out some preliminary measurements for the traction bar.
Got the engine in as well as a makeshift 3 spd and t-case. Waiting on the automatic trans to be done.
Clay using some hi tech tape to mark out some preliminary measurements for the traction bar.