Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
engine taching a bit high?
#5
You should be looking at 2050 RPM assuming your third gear on the C6 is 1.00.

Considering your current RPM, you are looking at a rear end ratio of 5.71 which I seriously doubt you have so there must be some other factor involved.

Can you pull more speed / gear data throughout the enitre range so we can look at them?

If the RPM were high at idle and other ranges I would have a few possibilities for you but if it is just in the high gears I will have to sit on it and think.

Are you carb or EFI?
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.Confusedmokin:
Roads? Where we're going, we don't need roads.

[Image: sig2.jpg]
Reply


Messages In This Thread
engine taching a bit high? - by bowtieman55 - 03-27-2008, 07:36 PM
engine taching a bit high? - by chuzie - 03-27-2008, 07:42 PM
engine taching a bit high? - by bowtieman55 - 03-27-2008, 07:58 PM
engine taching a bit high? - by blazinchuck - 03-27-2008, 08:43 PM
engine taching a bit high? - by chuzie - 03-27-2008, 09:40 PM
engine taching a bit high? - by justin - 03-28-2008, 10:52 AM
engine taching a bit high? - by bowtieman55 - 03-28-2008, 11:18 AM
engine taching a bit high? - by chuzie - 03-28-2008, 05:42 PM
engine taching a bit high? - by justin - 03-29-2008, 04:46 PM
engine taching a bit high? - by chuzie - 03-29-2008, 05:37 PM
engine taching a bit high? - by justin - 03-29-2008, 11:33 PM
engine taching a bit high? - by justin - 04-01-2008, 12:48 PM
engine taching a bit high? - by chuzie - 04-01-2008, 08:05 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Automatic Trans: Why does the engine die as soon as I put it in Park or Neutral???? UTFLIWGYA 6 3,951 05-15-2014, 11:50 AM
Last Post: rbodine
  Engine help snipes243 12 3,331 02-21-2014, 12:06 AM
Last Post: chuzie
  Can firing order determine engine block size? 1st Bronco 1 785 08-16-2013, 06:26 PM
Last Post: blazinchuck
  5.0/nv3550...engine now dies at stops*help* blazinchuck 14 3,477 06-09-2013, 10:50 AM
Last Post: chuzie
  1996 5.8 L Engine Rebuild- Cylinder heads jrshepherd 0 2,580 07-17-2011, 11:13 AM
Last Post: jrshepherd
  Engine Rebuild. 1996 5.8 L jrshepherd 0 980 05-05-2011, 02:02 AM
Last Post: jrshepherd
  new engine berg bronco 21 4,164 05-12-2009, 11:38 PM
Last Post: supertoyota88
  Engine build advice cuz1 6 1,546 06-27-2008, 05:35 PM
Last Post: bucketobolts

Forum Jump:


Users browsing this thread: 5 Guest(s)