Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
1977 Ford Bronco rear ended 9" rebuild
#7
Yeah, I recall that. I'd remove the shims and just change the perch angle. You can remove one and tack a new one on at whatever degree you want. Angle finders are cheap and necessary. I wouldn't weld the perches fully until final mock up. You want the pinion a degree or 2 lower than the driveshaft angle. It isn't hard to do just takes time and attention.
Reply


Messages In This Thread
1977 Ford Bronco rear ended 9" rebuild - by broncosbybart - 12-13-2016, 06:03 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  1996 Ford Bronco- Body Bushing Install jrshepherd 2 2,411 09-19-2018, 02:50 PM
Last Post: blazinchuck
  Stainless/ Coated Headers needed- 1995 Bronco 351 Windsor .20 over trick flow heads jrshepherd 1 3,230 05-22-2018, 09:38 PM
Last Post: broncosbybart
  Rebuilding used rear leaf springs Crawdad 5 4,293 12-12-2016, 11:54 AM
Last Post: Crawdad
  BC Bronco Soft Top knoxville714 3 3,132 07-12-2016, 08:04 PM
Last Post: blazinchuck
  1996 Bronco New BSD 4" long arm lift on IFS suspension- Setting Wheelbase jrshepherd 11 3,815 01-31-2016, 03:55 PM
Last Post: broncosbybart
  Lighted rear view mirror chuzie 6 4,723 06-20-2015, 12:18 AM
Last Post: chuzie
  Another Bronco Floor Replacement jdowns67 83 14,399 12-20-2014, 11:33 AM
Last Post: jdowns67
  rear main seal snipes243 5 2,986 05-03-2014, 11:45 AM
Last Post: chuzie
  stock rear drums scbronco 11 2,624 03-06-2014, 08:09 PM
Last Post: Bronco Biff
  Late 70s Cadi rear disc brakes for 77 banjo rear end Crawdad 11 3,888 01-11-2014, 12:26 AM
Last Post: Crawdad

Forum Jump:


Users browsing this thread: 1 Guest(s)