04-04-2008, 09:22 PM
I didn't get to work on the truck yesterday but today I got off work early and started in on reassembling the front end. I got the inner fenders bolted in and then I took the plastic wheelwells and trimed those and bent them up and screwed the trimmings to the inner fender I will get pics tomorrow cause that is a bit hard to imagine. I had to get the radiator supports relocated for the 4.0L radiator, and then mount the trans cooler I got the cooler plumbed and the radiator all hooked back up. I got all the wires put back where they belong and noticed something cool about all the lights up front on each side of the truck there is a total of 3 light sockets 1 is the head light 1 is the front turn signal and 1 is the side marker light out of the 3 the only rewire i need to do is the head light the plugs don't match up but the other 2 the sockets from the second gen lights will twist in to the gen1 light housings this is cool because now I don't have to rewire all of the lights. I found that i am gonna have to adjust the amount of sheetmetal that I am planning on trimming so it doesn't look stupid if I trim it as much as I had originally planned you will see some of the core support and I don't want that. all I have left is to FINISH hahahaha