04-04-2008, 10:15 PM
ohhhhhhhhhh baby these are some pretty rotors. today I pulled the axlle shafts out so I could install the new ebrake shoes and hardware that is the only way to put ne shoes on that thing. I waited around all day for the big brown truck but it never came to the house the dick head took them to my wife's place of employment cause it is down the road and no one is usually home when he comes so he just started droping all of my packages off with her. but anyways when she got home I put the new rotors and pads on all that is left is flaring my brake lines but I goota get a couple of the fittings off of my other axle to make them. I managed to haul the new axle over to the inlaws and weld the tubes to the diff case and as I finished the weld I ran out of wire but no biggie the guy that i installed the cherokee lift for said he had a roll of wire for me so he brought that by and now I am just waiting for tomorrow and see what the weather is gonna do if it is dry I will be installing the new axle. My plan is to get the axle centered and then tighten up the u bolts and tack the perches in and then pull the axle back out where I can work on it cause I gotta weld some tabs to hold the flexible brake lines since they were bolted to the old sway bar perches. I will get some pics up tomorrow after the swap. maybe do a bs writeup not like anyone really needs it. Shit I still need to work on the 4.0 write up that will probably never get done there is to much to write about and I think them bs write ups they did for TRS are a waste of time they give you just enough info to get you in over your head.