Carolina Broncos › 66-96 Ford Broncos › Bronco Tech v
Locking down the front

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
Locking down the front
mudmonkey Offline
Member
***
Posts: 112
Threads: 13
Joined: Jun 2008
Reputation: 0
#11
10-22-2008, 08:57 PM
chuzie Wrote:Money is an issue right now .

For a 12 pack I'll weld that sucker for yaConfusedupergrin:
General Jon
Find
Reply
chuzie Offline
Administrator
*******
Posts: 4,530
Threads: 131
Joined: Nov 2005
Reputation: 0
#12
10-22-2008, 09:55 PM
I installed the Lock Right in my 9" rear and it was a cinch so can't wait to put another one in the front which will be even easier.

The only reason I ever wheel at 5K is because I am having the push my front tire through the soup. Pretty sure than will no longer be an issue.

Kind of sucks that I just made this decision only 24 hours after I sealed up the front end from the fluid change. Time to drop an extra $3 on another gasket!

Oh, looks like JP will get his seal write-up too, along with the locker install, since I am going to be in the area anyway.

THanks for the help guys.

BTW- Found a lock right for 235.00 so works for me. Just gotta keep it a secret from the wife since I was bitchin about her doing so much shopping this week.
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.Confusedmokin:
Roads? Where we're going, we don't need roads.

[Image: sig2.jpg]
Website Find
Reply
chuzie Offline
Administrator
*******
Posts: 4,530
Threads: 131
Joined: Nov 2005
Reputation: 0
#13
10-26-2008, 12:21 PM
I went to pull the carrier out this morning and it looks like the outer races are rusted to the axle housing. The inner races are free because it turns just fine.

I gave it hell to get it out and it is not budging. I tried penetrant and a heat source, a ratchet strap, and even an air hammer (in moderation) and nothing works. I want to be careful not to damage the housing.

Any suggestions?
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.Confusedmokin:
Roads? Where we're going, we don't need roads.

[Image: sig2.jpg]
Website Find
Reply
gulfcrestinc Offline
Member
***
Posts: 55
Threads: 5
Joined: Jun 2008
Reputation: 0
#14
10-26-2008, 01:21 PM
you may want to rent a housin spreader. it may help out. i'm goin with a powr-lok in the front of my 76' i've started on. it locks up hard but isn't as hash as a locker.
Website Find
Reply
chuzie Offline
Administrator
*******
Posts: 4,530
Threads: 131
Joined: Nov 2005
Reputation: 0
#15
10-26-2008, 03:31 PM
Where can you rent those? I know autozone does not have that in their inventory. Maybe I can fab one.
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.Confusedmokin:
Roads? Where we're going, we don't need roads.

[Image: sig2.jpg]
Website Find
Reply
chuzie Offline
Administrator
*******
Posts: 4,530
Threads: 131
Joined: Nov 2005
Reputation: 0
#16
10-26-2008, 05:20 PM
Nevermind. I got it out with my big ass cheater bar!
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.Confusedmokin:
Roads? Where we're going, we don't need roads.

[Image: sig2.jpg]
Website Find
Reply
gulfcrestinc Offline
Member
***
Posts: 55
Threads: 5
Joined: Jun 2008
Reputation: 0
#17
10-26-2008, 06:26 PM
that's the spirt!
Website Find
Reply
chuzie Offline
Administrator
*******
Posts: 4,530
Threads: 131
Joined: Nov 2005
Reputation: 0
#18
10-26-2008, 06:42 PM
just hope i can get it back in!!!
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.Confusedmokin:
Roads? Where we're going, we don't need roads.

[Image: sig2.jpg]
Website Find
Reply
chuzie Offline
Administrator
*******
Posts: 4,530
Threads: 131
Joined: Nov 2005
Reputation: 0
#19
10-26-2008, 07:25 PM
Someone please confirm this is the right seal for my axle. The idiots gave me the wheel seal today and now I have to go back.

The description show rear wheel but I am pretty sure this is front axle.

http://www.napaonline.com/MasterPages/NO...Front+Axle

thx.
'77 351w- Explorer EFI, 4R70W, 4-link, lockers, 4.56, 35" MT/Rs with a severe rock addiction.Confusedmokin:
Roads? Where we're going, we don't need roads.

[Image: sig2.jpg]
Website Find
Reply
bucketobolts Offline
Posting Freak
*****
Posts: 1,319
Threads: 42
Joined: Oct 2006
Reputation: 0
#20
10-26-2008, 08:47 PM
Looks right to me.Confusedcratchhe:
'72 TBA...
Find
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Locking Hubs?? Whats the best??? Broncitis 9 6,697 02-26-2017, 01:51 PM
Last Post: snipes243
  Front shock mounts snipes243 14 3,949 03-01-2015, 07:51 PM
Last Post: scbronco
  Front D44 Ring/Pinion and upgrades scbronco 17 2,944 12-31-2010, 10:07 PM
Last Post: scbronco
  Used front hub jdowns67 2 986 10-31-2010, 11:06 AM
Last Post: jdowns67
  Front Axle Olredneck 0 866 09-03-2009, 08:44 PM
Last Post: Olredneck
  Bronco Front Rear Question 2000F150SAS 8 1,792 05-28-2009, 02:22 AM
Last Post: supertoyota88
  1990 Bronco Front Locking Hub Question 2000F150SAS 16 5,618 05-21-2009, 04:29 PM
Last Post: 2000F150SAS
  1990 Front End Alignment Question 2000F150SAS 5 2,246 12-30-2008, 07:32 AM
Last Post: 2000F150SAS
  Front disk/Rear window tapiot 2 1,748 08-23-2008, 08:49 PM
Last Post: tapiot
  Front wheels jerk when in 4X4-any ideas? cwdanie 11 5,003 08-02-2008, 10:43 PM
Last Post: cwdanie

Forum Jump:


Users browsing this thread: 5 Guest(s)