Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
79 F150 Dana 44 Axle Question
#1
We just pulled our 79 Dana 44 apart last night and found a couple of problems. This will be a street, trail, and beach truck, no heavy wheeling.

Driver side outer axle - the splines are a little screwed up from the snap ring out, is this a problem?

Passenger side outer axle - the smooth part of the axle next to the splines has a few grooves. These grooves are about 1/4" in width, smooth, but not that deep, is this a problem?

Thanks
Reply
#2
pass side, i'd run it.
driver side, probably be ok no harder then you plan on pushing it.
East Coast Surplus & Tactical
336-674-3868
Reply
#3
Broncomania,

Would you or know of anyone in the area which may have a extra outer axle (stock ford)? I don't like the pass. side one and since we are rebuilding the axle from end to end i think i would like to replace it.

Thanks, John
Reply
#4
2000F150SAS Wrote:Broncomania,

Would you or know of anyone in the area which may have a extra outer axle (stock ford)? I don't like the pass. side one and since we are rebuilding the axle from end to end i think i would like to replace it.

Thanks, John
not right now .
East Coast Surplus & Tactical
336-674-3868
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Steering shaft Extension Question??? Broncitis 4 2,865 04-17-2015, 02:27 PM
Last Post: Broncitis
  Exhaust question Casey835 27 7,206 08-16-2013, 06:03 PM
Last Post: blazinchuck
  Axle Tube Vents Casey835 4 1,429 03-01-2013, 08:20 PM
Last Post: Casey835
  ***9" Axle Gurus...Ring gear dug into pilot housing!** chuzie 7 2,445 12-05-2012, 12:35 AM
Last Post: chuzie
  dana 44 mods 64500xl 8 1,789 07-06-2012, 08:44 PM
Last Post: chuzie
  Axle / Gear gurus help!! SC74 4 2,454 03-28-2012, 08:52 AM
Last Post: SC74
  1991 351W EFI Question Crawdad 4 2,096 03-27-2012, 09:05 AM
Last Post: broncosbybart
  F150 axle shaft tech blazinchuck 12 3,129 12-03-2011, 09:34 PM
Last Post: broncosbybart
  Hard top Question 744x4 5 4,197 09-06-2011, 10:32 PM
Last Post: Mill Knob
  Tire question dixieboyz13 12 4,557 08-25-2011, 01:58 PM
Last Post: ncsubronc

Forum Jump:


Users browsing this thread: 1 Guest(s)