08-27-2009, 10:04 PM
Yup ... that's what I meant by a die.
I just measured mine and for 3/16 tube you need .150 sticking out for the first flare
with the little black die / insert. That should push it down flush with the clamp prior to the final forming without the die.
Good luck ... hope all this helps.
I just measured mine and for 3/16 tube you need .150 sticking out for the first flare
with the little black die / insert. That should push it down flush with the clamp prior to the final forming without the die.
Good luck ... hope all this helps.