09-21-2010, 03:43 PM
Yes, on the flange above the lug stud area. Should be fairly strait.
If you have mared up the inside of the axle housing you can put a thin bead of silicone on the housing where the seal sits. That will keep it from leaking by the seal.
Of course you do need to make sure there are no grooves in the axle shaft. If so you will need a sleeve kit.
If you have mared up the inside of the axle housing you can put a thin bead of silicone on the housing where the seal sits. That will keep it from leaking by the seal.
Of course you do need to make sure there are no grooves in the axle shaft. If so you will need a sleeve kit.
[SIGPIC][/SIGPIC]