01-26-2013, 01:36 AM
(This post was last modified: 01-26-2013, 01:39 AM by broncosbybart.)
My tank reads 1/2 full when it is full... I have a new sending unit that I will calibrate and install.
I think chuck at bc was referring to the vent line for the filler neck. I don't think you need to vent the tank like you were describing.
One quick check you can do is to check the ohm reading at the sender and then check it at the gauge. My guess is about 45 ohms at half full. Can't remember the exact figure. There is a thread on classic chuck posted a while back
I think chuck at bc was referring to the vent line for the filler neck. I don't think you need to vent the tank like you were describing.
One quick check you can do is to check the ohm reading at the sender and then check it at the gauge. My guess is about 45 ohms at half full. Can't remember the exact figure. There is a thread on classic chuck posted a while back