03-15-2015, 09:27 PM
I can finally say that I worked on my bronco today! HOT DAMN IT FELT GOOD TOO! I bought some old and rusty rear springs from BroncoMatt about 10 months ago and I finally got around to removing the old hardware off the spring eyes. After lots of delicate cutting and about a half dozen drill bits I finally got it all off. Hope these things are salvageable as I plan to have them sandblasted and some rattle can paint and primer will be just fine. I imagine I could go to a driveline garage and pick up some new hardware as the one pictured are breaking off.
As far as the frame it's still in the same spot it was in two years ago. But thanks to a pretty tax return I can begin sanding down the frame and take down to the powder coater. Updated my membership status too, felt guilty posting anything on my build thread without supporting this site.
As far as the frame it's still in the same spot it was in two years ago. But thanks to a pretty tax return I can begin sanding down the frame and take down to the powder coater. Updated my membership status too, felt guilty posting anything on my build thread without supporting this site.
[SIZE="2"]77 project bronco w/ 5.0 & c4, Sagi PS, 2 hard tops, eyebrow grill [/SIZE]
WANTED: auto column, gas tank, front/ rear seats
WANTED: auto column, gas tank, front/ rear seats